These instructions are for Windows-based scanners and assume a working knowledge of Windows and general workstation setup procedures. Complete the installation of the hardware and software in the order presented within this document.
| IMPORTANT: |
|---|
| The motion platform must be turned off prior to installing in order for the DigiSize software to properly function. |
This installation guide assumes that you will have access to a CD-ROM that was supplied to you upon delivery of your Cyberware Digitizer. If you do not have access to this CD-ROM, please consult with Cyberware Support for more information.
There are currently three types of installations detailed below:
The following instructions are for installing a USB-based Cyberware 3D scanner and the supporting software. These instructions are broken into the sections below and should be followed in the order presented here:
The following instructions are for installing a SCSI-based Cyberware 3D scanner and the supporting software. These instructions are broken into the sections below and should be followed in the order presented here:
The following instructions are for a software only installation. If you have a Cyberware scanner, please consult the instructions in the USB-Based Installation Instructions or SCSI-Based Installation Instructions section. The following instructions are broken into sections below and should be followed in the order presented here:
If you run into difficulty while installing a scanner, please consult the Troubleshooting Guide.
For information on software removal, please consult this section of the user guide.