This document provides information on procedures for the advanced user of Cyberware hardware and software. Under no circumstances should a user attempt these procedures, except under the direction of a Cyberware technician. These procedures permanently modify the scanner's settings and there is no ability to revert to the previous or factory default settings.
| Procedure | Purpose |
|---|---|
| Save USB Configuration Files | Use this procedure to save the EEPROM configuration to plain text files. |
| Load the Factory Configuration | This procedure may be used to reset the scanner's EEPROM to the factory default settings or to load plain text configuration files into the scanner's EEPROM. |
| Reload the Factory Configuration | This procedure may be used to reset the scanner's EEPROM to the factory default settings. |
| Link Cyberware Devices | Associates each Cyberware device to the others in order to create a complete scanner setup. |
| Reset the USB Link | This procedure will reset the USB setup and remove Cyberware entries from the Registry. |
| Switch Motion Platforms | This procedure outlines the steps to move a 3030 scanhead from one motion platform to another and enable the software to work with this type of setup. |
| Set the posAfter* Variables | Use the procedure to modify the posAfterHome and posAfterScan variables on a Cyberware Head & Face 3D Scanner. |
| Adjust the Home Position | This procedure details the procedure to adjust a Cyberware Whole Body 3D Scanner's (Model WBX) home position. |